Rockwell Automation 6180 Industrial Computers - Manual (Page 117)

Adding and Removing Displays and Backlights 10–5
Publication 6180-6.0
15. Replace the four backlight mounting screws and tighten to a torque
of 6 to 8 inch-pounds (.7 to .9 N_m).
16. Swing the chassis back into position and tighten the three latching
screws to a torque of 18 to 22 inch-pounds (2 to 2.5 N_m).
17. Reconnect and install any external cables or mounting clips.
18. Apply power and verify operation of the backlight.
To replace the backlight (12.1 inch displays only):
1. Disconnect the power from the 6180 Computer.
2. Remove two screws each from the backlight assembly.
3. Disconnect the two cables from the power supply.
4. Remove the backlight assembly.
To replace the backlight (15 inch displays only): ):
1. Disconnect the power from the 6180 Computer.
2. Remove two screws each from the backlight assembly.
3. Disconnect the two cables from the power supply.
4. Remove the backlight assembly.
Replacing the 12.1 inch
Display Backlight
Replacing the 15 inch
Display Backlight