Rockwell Automation 6180 Industrial Computers - Manual (Page 71)

Adding and Removing System Components 4–3
Publication 6180-6.0
3. To re–install back panel, position back panel tabs over the chassis
and tighten the 2 screws (6-8 in./lb.)
ISA compatible boards may be installed in any of the ISA slots or the
ISA/PCI shared slot. PCI compatible boards may be installed in any one
of the PCI slots or the ISA/PCI shared slot.
Note:
If a floppy or other device is installed in the lower bay, the
lower three slots are restricted to half-length cards.
Refer to the Processor Board manual for the type and number of slots
supported by your computer.
ATTENTION: Review safety precautions on page 4
−
1
before proceeding. Failure to follow proper safety
procedures could result in severe electrical shock or
damage to the 6180 Computer.
ATTENTION: Add-in boards may be sensitive to ESD
and require careful handling. Hold boards only by the
edges, do not touch connectors. After removing a board,
place the board on a flat static free surface, component
side up. Do not slide the board over any surface.
To remove a slot cover (to add a board):
Figure 4- 2
Adding and Removing
Add-in Boards