Rockwell Automation 6180 Industrial Computers - Manual (Page 72)

4–4 Adding and Removing System Components
Publication 6180-6.0
1. Remove the back panel. See page 4-2.
2. Locate the slot cover you want to remove. We recommend that you
remove adjacent add–in boards.
3. Remove the screw securing the slot cover and remove cover.
To install a slot cover (after removing a board)
1. Insert the end of the cover into the slot in the chassis.
2. Install the screw securing the slot cover, tighten to 6–8 in–lbs (.7–.9
N•m)
To install an add–in board:
1. Remove the board from its anti–static packaging and place on a
grounded, static free surface.
2. Set any board jumpers or switches as described in the instructions for
the board.
3. Hold the board by the edges and firmly press the board into the
connector on the processor board.
Figure 4- 3