Rockwell Automation 6180 Industrial Computers User Manual
Page 75
Advertising
Adding and Removing System Components
4–7
Publication 6180-6.0
Figure 4- 5
!!emove!seven!screws
at these locations.
!!he!!entium!
motherboard is
shown. The
Pentium II
motherboard
uses ten screws.
To install the processor board:
1. Position the board in the chassis and align the screw holes with the
stand–off spacers on the chassis.
2. Secure the processor board with the 6 screws (shown above).
Tighten screws to 6–8 inch–pounds (.7 to .9 N•m).
3. Secure the side board with the 3 mounting screws. Tighten screws to
6–8 inch–pounds (.7 to .9 N•m).
4. Connect all cables and connectors including the IDE drive cable and
front header panel connectors.
5. Install all add–in boards. See page 4-7.
Advertising