Rockwell Automation 6180 Industrial Computers - Manual (Page 106)

8–4 Adding and Removing Data Storage Drives
Publication 6180-6.0
2. Position the drive / bracket assembly into the chassis. Make sure the
tabs on the side of the bracket slide into the corresponding side hole
in the chassis. Also make sure that the key on the end of the bracket
is inserted into the slot on the chassis front panel.
3. Secure the drive / bracket assembly to the chassis with the two
mounting screws. Tighten screws to a torque of 6–8 in–lbs.
4. Install the ribbon connector on the hard drive. On 3.5 inch drives
also connect the power cable. Make sure that the ribbon cable is
installed correctly. The red wire of the cable must be at the bottom
as shown below. Connect the other side of the IDE ribbon cable to
the motherboard.
Figure 8- 4
5. Install the back panel.
6. Apply power and verify the operation of the drive. Refer to any
additional instructions provided with the drive.
Master and Slave Jumper Settings
Need text????