Rockwell Automation 6180 Industrial Computers - Manual (Page 180)

B–2 European Union Directive Compliance
Publication 6180-6.0
The 6180 Industrial Computers are intended for use solely in an
industrial environment as defined above. When installed in Europe, any
other application is in contravention of European Union Directives, and a
breach of these laws.
Wiring Recommendations
To reduce electrical noise, connect the 6180 Industrial Computer to its
own branch circuit. The input power source should be protected by a
fuse or circuit breaker rated at no more than 15 Amps. Route incoming
power to the 6180 Industrial Computer by a separate path from the
communications cables.
Where power and communications lines must cross, they should cross at
right angles. Communications lines can be installed in the same conduit
as low level DC I/O lines (less than 10 Volts).
Declarations of Conformity
The Declaration of Conformity is available at the Rockwell Automation /
Allen–Bradley Internet site: www.ab.com
This document declares that the computers conform to the applicable
directives.