Rockwell Automation 6180 Industrial Computers - Manual (Page 116)

10–4 Adding and Removing Displays and Backlights
Publication 6180-6.0
Figure 10- 4
9. Note the following precautions before swinging the chassis away
from the bezel.
ATTENTION: Remove all external cables from the side
panel connectors. Failure to remove cables may cause
damage to the cables and connectors.
ATTENTION : If the 6180 Computer is installed with
mounting clips, the mounting clips on the hinge side will
interfere with the opening of the hinge. Remove the
mounting clips on the hinge side before swinging chassis
away from the bezel. Failure to remove clips may
damage clips and the chassis.
10. Swing the chassis open about 90 degrees.
11. Remove four screws that secure backlight and remove the backlight
to allow access to the power connector
12. Unplug the backlight power supply cable and remove the backlight.
13. Plug the backlight power supply cable into the new backlight.
14. Place the backlight on the four backlight standoffs.