Rockwell Automation 6180 Industrial Computers - Manual (Page 167)

Maintenance Maintenance Maintenance Maintenance
This chapter describes routine maintenance procedures for:
•
cleaning the display
•
cleaning the chassis fan filter
•
cleaning the power supply filter
Note:
See the procedures for replacing the SD104 and SD150
backlights earlier in this manual.
Clean the 6180 Computer with the front panel access doors closed.
ATTENTION: Use of abrasive cleansers or solvents may
damage the display window. Do not scrub or use brushes.
To clean the display:
1. Disconnect power from the 6180 Computer at the power source.
2. Using a clean sponge or a soft cloth, clean the display with a mild
soap or detergent.
3. Dry the display with a chamois or moist cellulose sponge to avoid
water spots.
Removing Paint and Grease
Remove fresh paint splashes and grease before drying by rubbing lightly
with isopropyl alcohol. Afterward, provide a final wash using a mild
soap or detergent solution. Rinse with clean water.
ATTENTION: Make sure the isopropyl alcohol does not
come in contact with the equipment labels. Alcohol may
cause the label printing to smear.
Chapter Chapter Chapter Chapter
16
Chapter Objective
Cleaning the Display