Rockwell Automation 6180 Industrial Computers - Manual (Page 74)

4–6 Adding and Removing System Components
Publication 6180-6.0
Figure 4- 4
4. Disconnect the hard drive IDE cable connector.
5. Disconnect the floppy drive connector.
6. Disconnect the front header panel connector.
7. The side board (shown previous page) restricts access to the upper
left mounting screw of the processor board. Remove the 3 screws
that secure the board, you do not need to unplug any connectors from
the side board. Gently move the side board to allow access to the
processor board (upper left) mounting screw.
8. Remove the screws that secure the processor board and remove the
board. Place board in an anti–static wrapper.