Rockwell Automation 6180 Industrial Computers - Manual (Page 83)

Adding and Removing Adding and Removing Adding and Removing Adding and Removing
Processors
Processors Processors Processors
This chapter describes how to remove and install processors.
The 6180 Pentium III processor board has a 370 socket that supports a
processor upgrade migration path that includes higher performance
Pentium III processors. The 6180 Computer Pentium processor board
has a type 7 socket which supports the Pentium process.
The types of processors supported are:
•
Pentium Classic-166Mhz and 233Mhz
•
Slot 1-PII and PIII
•
Phase 2 (or 4) PS/Finned H. S.
•
Phase 3 P. S.
•
Phase 4 P. S. with Puma H. S.
ATTENTION: Disconnect all power from the 6180
Computer before removing components. Failure to
disconnect power could result in severe electrical shock
or damage to the 6180 Computer.
ATTENTION: Wear a wrist strap (well grounded) and
perform work in a static safe environment. Electrostatic
discharge can damage the 6180 Computer and
components.
To remove the processor:
1. Disconnect the power from the 6180 Computer.
2. Remove the back panel. (See page 4-2).
Chapter Chapter Chapter Chapter
6
Chapter Objective
Installing and Removing
Processors