Rockwell Automation 6180 Industrial Computers - Manual (Page 86)

6–4 Adding and Removing Processors
Publication 6180-6.0
Figure 6- 3
5. Remove the spring clamp, heat sink, and conductive pad.
ATTENTION: When the socket lever is raised, the
processor is loose in the socket. Make sure the processor
does not drop out of the socket.
ATTENTION: Do not remove any heat conductive
grease from the conductive pad. Be careful not to damage
the conductive pad. Damage to the pad or removal of
conductive grease may result in overheating and failure of
the processor.
6. Press lightly down and out on the lever of the processor socket until
the lever can be pulled up.
7. Note the orientation of the processor and remove the processor from
the socket. Do not touch or bend the pins.