Rockwell Automation 6180 Industrial Computers - Manual (Page 49)

Installation 2–13
Publication 6180-6.0
Figure 2- 9
6. Tighten mounting clips to a torque of 10 inch–pounds (1.1 N•m) in
the sequence shown above. Do not over–tighten.
ATTENTION: Tighten mounting clips to a torque of 10
inch pounds (1.1 N•m) to provide a proper seal and
prevent damage to the 6180 Computer. Allen–Bradley
assumes no responsibility for water or chemical damage
to the terminal or other equipment within the enclosure
because of improper installation.
Note:
The mounting clips on the hinge side interfere with the
opening of the hinge. Remove the clips before opening the
hinge.