Rockwell Automation 6180 Industrial Computers - Manual (Page 99)

Adding and Removing Removable Media 7–9
Publication 6180-6.0
Figure 7- 8
2. Remove the back panel to the 6180 Computer. See page 4-2.
3. A shorter drive cable is provided with the mounting kit for mounting
in the upper bay. Connect the cable to the floppy drive connector on
the processor board (refer to the Processor Board user manual if
necessary) and the connector on the back of the drive.
4. Position the accessory drive / bracket assembly into the chassis. The
edge of the bracket fits under the tab at the front of the chassis.
Note:
You may have to remove the side panel knockout
(shown below) if a side mounted drive was not
previously installed. Insert screwdriver into slot on
knockouts and pry back and forth on knockout to
remove. Use a pliers to remove the center rib between
the two knockouts.
ATTENTION: If knockout is removed, carefully remove
any burrs or sharp edges. Failure to remove sharp edges
could result in personal injury.
5. Align the bracket and chassis mounting hole and secure the drive /
bracket assembly with a mounting screw. Tighten screw to a torque
of 6–8 in. lbs (.7–.9 N•m).