Rockwell Automation 6180 Industrial Computers - Manual (Page 66)

3–6 Initial Operation and Setup
Publication 6180-6.0
Marking the legend strip
When custom labeling the legend strips, use an indelible type of marker.
All printing must appear within the white text areas. We recommend that
you test print the legends on a separate sheet of paper to verify that the
insert has adequate space for the legends.
To reverse or change a legend strip:
1. Carefully pull the legend strip from the left side behind the bezel.
Figure 3- 2
2. If you are using the blank legend strips, mark the legends on the matt
surfaces provided for marking.
3. Re–insert the tab into the slot. Here are some helpful hints:
•
Grip the legend strip near the point where the strip enters the slot
and use short “pushes”. This helps prevent buckling of the
legend strip.
•
It may be helpful to “cup” the legend strip slightly as you hold it.
This will stiffen the legend strip and also prevent buckling.