Rockwell Automation 6180 Industrial Computers - Manual (Page 85)

Adding and Removing Processors 6–3
Publication 6180-6.0
Figure 6- 2
4. Refer to the following figures (the 6180 Computer has two types of
processors). While holding the heat sink, use pliers to carefully pull
the spring clamp from the tab on the socket.
ATTENTION: The spring clip fits tightly on the socket
base. Use extreme caution when using a needle nose
pliers to remove the spring clip. Make sure pliers do not
slip and damage the processor board.
ATTENTION: The spring clamp secures the heat sink to
the processor. When the clamp is removed, the heat sink
will slide off. Make sure the heat sink does not fall onto
other components.