Rockwell Automation 6180 Industrial Computers - Manual (Page 8)

P–2 Using this Manual
Publication 6180-6.0
Chapter Title Contents
Preface Describes the purpose, background,
and scope of this manual. Also
specifies the audience for whom this
manual is intended.
1 System Features Shows the different versions of the
6180 Computer and system features.
2 Installation Describes how to install the 6180
Computer in a panel or enclosure.
Also tells how to connect devices
(such as mouse or keyboard) to the
system.
3 Initial Operation and
Setup Tells how to start and check out the
system.
4 Adding and
Removing System
Components Gives procedures for adding and
removing the back panel accessory
drive cover, add–in boards, and
processor board.
5 Adding and
Removing memory Gives procedures for adding and
removing memory
6 Adding and
Removing
Processors Gives procedures for adding and
removing processors.
7 Adding and
Removing
Removable Media Gives procedures for adding and
removing removable media.
8 Adding and
Removing Data
Storage Drives Gives procedures for adding and
removing data storage drives.
9 Adding and
Removing Power
Supplies Gives procedures for adding and
removing power supplies.
10 Adding and
Removing Displays
And Backlights Gives procedures for adding and
removing displays and backlights.
11 AB Video Cards Explains how to use video cards in
the 6180 Computer.
12 AB Keypad Interface
Cards Explains how to use keypad interface
cards in the 6180 Computer.
13 Keypad
Configuration Utility
Software Gives procedures on how to use the
Keypad Configuration Utility software
in the 6180 Computer.
14 Touchscreen Drivers
and Utilities Explains how to use touchscreens in
the 6180 Computer.
15 System
Troubleshooting Explains how to interpret and correct
problems with the 6180 Computer.
16 Maintenance Gives procedures for cleaning the
6180 Computer display, and other
components.
Contents of this Manual