Rockwell Automation 6180 Industrial Computers - Manual (Page 115)

Adding and Removing Displays and Backlights 10–3
Publication 6180-6.0
To install a bezel display:
1. Secure the bezel/display to the chassis by aligning the hinges and
installing the hinge pin.
2. Connect the electrical connectors between the bezel/display and the
chassis. The connectors are different sizes and each is keyed so that
they cannot be installed incorrectly. Do not force a connector.
3. Swing the chassis closed. Make sure the bezel/display cables and
connectors move freely and do not crimp when the chassis is closed.
4. Secure the chassis with the three latching screws. Use the new
screws provided.
5. Mount the 6180 Computer in the enclosure or panel.
6. Apply power and verify operation of the display.
To replace the backlight (10.4 inch displays only):
7. Disconnect the power from the 6180 Computer.
8. Remove the three latching screws that secure the chassis to the front
bezel.
Replacing the 10.4 inch
Display Backlight