Rockwell Automation 6180 Industrial Computers - Manual (Page 70)

4–2 Adding and Removing System Components
Publication 6180-6.0
This section shows how to remove the back cover to access internal
components.
ATTENTION: Review safety precautions on page 4-1
before proceeding. Failure to follow proper safety
procedures could result in severe electrical shock or
damage to the 6180 Computer.
To remove the back panel:
1. Disconnect power from the 6180 Computer.
2. Loosen the 2 screws securing the back panel. The screws are
retained and cannot be removed from the panel.
Figure 4- 1
Removing the Back Panel
and Accessory Drive
Cover