Fluke Biomedical VT Plus HF - Manual (Page 46)

VT Plus HF
Operators Manual
2-18
Errors
When an error is made, the Analyzer signals it with a beep. This option adjusts the sound
level of that beep.
To adjust the sound level of errors:
1. Highlight
Errors and press the MODIFY soft key to toggle between Low , High , or
Off .
2. Press the ENTER soft key to save the change or the ESCAPE soft key to cancel the
change.
3. Press the BACK soft key to return to the Settings menu.
Restore Defaults
This option returns all values to the factory defaults listed below, but does not change the
device calibration.
To restore defaults:
From the
System menu, highlight Restore Defaults . The Analyzer restores system
values to the default, displays a Restoring to defaults. Please wait message.
After a few seconds, a beep indicates defaults are restored, and the display returns to the
System menu. Factory defaults are shown in Table 2-4.
Table 2-4. Factory Defaults
System
Date Format MM/DD/YYYY
Demo Data Off
Filtering None
Display Cal Date Yes
Serial Mode None
Printer Options
Printer Type None
Graphics Text Only
Audio Levels
General Low
Keypad Low
Errors Low
Settings
Gas Settings
Gas Type Air
Gas Temperature 22 ° C
Ambient Temperature 22 ° C