Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 112)

3-80 W A N s u i t e 5 1 6 0 / 5 1 3 0
corporate network “behind the NAT.” The parameters may be used only when
in NAPT mode.
Figure 3.72 Static UDP Translation Table Screen
Global Port Decimal IP Port exposed to the global Internet. Default is 0.
Server Port Decimal IP Port of the local UDP Server. This port is usually the same as the
Global Port. Default is 0.
Server Address IP Address of the local UDP Server. Default is 0.0.0.0.
The Static UDP Translation Table screen provides the following user-
activated buttons:
You can configure or change the above-listed parameters on the NAT Static
UDP Translation Details screen (Figure 3.73), which is accessed by selecting
the appropriate numbered link under the “Index” column on the Static UDP
Translation Table screen.
Figure 3.73 NAT Static UDP Translation Details Screen
NAT Port Table Screen
The parameters on the NAT Port Table screen (Figure 3.74) define the NAT
global/Internet and local/Corporate ports. These parameters are configured in
the NAT Ports Details screen shown in Figure 3.75. Access the NAT Ports
Details screen by clicking on the Index number of the desired port on the
NAT Port Table screen.
Button Function
NAT Details Returns the user to the previous screen.
Add New Lets the user add an additional address.