Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 22)

1-8 W A N s u i t e 5 1 6 0 / 5 1 3 0
The front panel LED status indicators are defined in the table below:
The front panel of the WANsuite 5130 (Figure 1.2) also provides three
user-activated input control buttons, four LED status indicators (although
different from the 5160), and a 2-line, 16-character liquid crystal display
(LCD) panel that provides access to unit configuration, diagnostics and
utilities.
Figure 1.2 WANsuite 5130 Front Panel
Indicator Description
NET This indicator is off (not illuminated) when the port has not been
configured.
The indicator lights green when the T1 link is up and all
configured protocol services are established.
The indicator lights red if the T1 link is down and the configured
protocol is not established.
The indicator lights amber
if the T1 link is up and at least one
configured protocol is not established.
#1 SERIAL and
#2 SERIAL DTR Alarm Enabled:
This indicator is off (not illuminated) when the port has not been
configured.
The indicator lights green when DTR is active and the configured
protocol is established.
The indicator lights red when DTR is not active and the
configured protocol is not established.
The indicator lights amber when DTR is not active or the
configured protocol is not established.
DTR Alarm Disabled:
This indicator is off (not illuminated) when the port has not been
configured.
The indicator lights green when the configured protocol is
established.
The indicator lights red when the configured protocol is not
established.
POWER This indicator lights green when power is applied to the unit.
The indicator lights amber in test modes (Port looped or BERT
active).