Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 37)

W e b S e r v e r I n t e r f a c e 3-5
Figure 3.3 Save and Restart Screen
Interfaces
The WANsuite 5160 has the following interfaces: Network 1, Network 2,
Serial 1, Serial 2, 10/100 Ethernet, and Supervisory. The WANsuite 5130 has
one Network and one Serial interface, but in other respects has the same
interfaces with the same parameters as the WANsuite 5160. Each of the
interfaces and their associated screens/menus are described below.
Network Screens
The WANsuite 5160 Network (Figure 3.4) screens let you view and make
changes to the Network interfaces’ configuration as described below. In
addition, the screens provide a table that displays the alarm values for the
Network interfaces. All Network ports operate in either long-haul or short-
haul mode. On the WANsuite 5160, the Network 1 and 2 screens are the same
except that at the top of the Network 2 screen (shown in Figure 3.5), there is
an additional parameter, “Function,” that’s described, along with the other
screen parameters, below.