Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 74)

3-42 W A N s u i t e 5 1 6 0 / 5 1 3 0
Applications
The Applications screens describe configuration tables and statistics for
Layer 3 and above that do not map to a specific service or interface.
Endpoint Table Screen
The Endpoint Table (Figure 3.36) describes all endpoints terminating in the
unit; links are provided to view the Endpoint Details, Endpoint Service
Details, and Endpoint DLCI Details screens. The unit will automatically learn
all DLCIs from the Network side and relay that information on the Serial side
with default values.
The Endpoint Table and its corresponding DLCIs will be saved in the
configuration database only after at least one endpoint parameter has been
changed and submitted in the Endpoint Details screen (page 3-42).
NOTICE: The Endpoint Table and its corresponding DLCIs will be saved in the
configuration database only after at least one endpoint parameter has
been changed and submitted in the Endpoint Details Screen on
page 3-43. When in IP Gateway, if you decide to use a “discovered”
endpoint, you must rename it. A discovered endpoint cannot be used
elsewhere (i.e., IP Gateway) until it has been renamed. Also, it will not
be saved in the configuration database.
NOTICE: Endpoint names of the form PPP-Sn and SCADA-Sn are reserved by the
system. These system-generated endpoints cannot be modified.
Figure 3.36 Endpoint Table Screen
For most applications, you will not have to modify the Endpoint Table and
DLCI Table. Modification is necessary, however, to configure remote in-band
management. (See In Band Management on page 3-46.)
Endpoint Details Screen
The Endpoint Details screen (Figure 3.37), which you access by clicking on
an Index number on the Endpoint Table, lets you access the configuration
parameters described in the paragraphs below.