Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 36)

3-4 W A N s u i t e 5 1 6 0 / 5 1 3 0
The Unit screen provides the following user-activated buttons:
Maintenance Reset Use this button to access a screen where you can perform a Maintenance
Reset (Figure 3.2). When you click on the arrow in the pull-down menu box
on the screen, you will have the option to perform a TDM, Packet, Packet 2,
Packet 3, or Packet 4 reset. When you select one of these options, all previous
configurations will be lost and the unit will be set back to the specified
factory default.
Figure 3.2 Maintenance Reset Screen
NOTICE: Performing a “Maintenance Reset” or a “Save and Restart” will
terminate communications with the unit.
Save and Restart Use this button to save the current configuration settings and then proceed
with a restart. Clicking the “Save and Restart” button on the Unit screen will
display a confirmation screen as shown in Figure 3.3 below. Click the “Save
and Restart” button on the confirmation screen to confirm the action.
Button Function
Submit Sets any values that have been changed. Use the top “Submit”
button to set any unit parameters changed in the upper section of
the screen, and the lower “Submit” button to set the real-time
clock.
Maintenance Reset Brings up a screen where you can reset unit to its default TDM
or Packet, Packet 2, Packet 3, or Packet 4 configuration.
Save and Restart Saves the current configuration and restarts the unit.