Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 188)

4-60 W A N s u i t e 5 1 6 0 / 5 1 3 0
distributes routing information between routers in a single autonomous
system. This Protocol is suitable for complex networks with a large number of
routers. If a large network is involved, OSPF may be the solution for the user.
Values: Disable, Enable
Default: Disable
OSPF Router ID This 32-bit number assigned to each router running the OSPF protocol
uniquely identifies the router within an Autonomous System. Each router
requires a unique router ID. Default is the LAN IP address of the unit.
The IP Gateway screen provides the following prompts that may be selected
by pressing the “Enter” key:
Circuit Table Screen
This menu shows the configured circuit. To configure a new circuit, select
"Add New."
Figure 4.52 Circuit Table Screen
Prompt Function
RIP Parameters
Static Route Table Displays static and dynamic route information.
Static ARP Table Displays static ARP information.
Trusted Neighbors Displays trusted neighbors information.
OSPF Parameters
Area Table Displays area information.
Virtual Link Table Displays virtual link information.
Circuit Table Provides user access to circuit-related information/
operation.