Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 215)

V T 1 0 0 I n t e r f a c e 4-87
Figure 4.85 Bridge Port Details
Enable Enables or disables Bridging on this port.
Endpoint Endpoint name.
BPDU Option Shows if BPDU packet will be sent and received on this port.
Filter By Multicast
Addr Dest
Filters multicast messages received on this port, which reduces the load on the
WAN connection.
Filter By Broadcast
Addr Dest
Filters broadcast messages received on this port, which reduces the load on
the WAN connection.
Forward IP Frames
Only
Setting this option to “Yes” specifies that only IP frames will be forwarded
and all other frames will be filtered.
Priority Value of priority associated with this port. The lower the value, the higher the
priority.
Path Cost Value of efficiency of the path to the port. A higher path cost indicates a
slower link.
State If Enabled, reflects the state of the port. “Blocking” means there is no data
transfer between LANs. “Listening” means the frames received from this port
are filtered, but do not modify the Lookup Table. “Learning” means that
while the port continues to look at frames without participating in data
transfer, the frames received from the port will be used to update the Lookup
Table. “Forwarding” means the port participates fully in data transfer and the
frames received are used to update the Lookup Table.
Designated Root MAC Address of the designated root of the spanning-tree topology.
Designated Cost Associated Path Cost to the route for this port.