Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 169)

V T 1 0 0 I n t e r f a c e 4-41
The Endpoint Table and its corresponding DLCIs will be saved in the
configuration database either when you perform a “Save and Restart” or
automatically every 15 minutes.
NOTICE: The Endpoint Table and its corresponding DLCIs will be saved in the
configuration database only after at least one endpoint parameter has
been changed and submitted in the Endpoint Details Screen on
page 4-42. When in IP Gateway, if you decide to use a “discovered”
endpoint, you must rename it. A discovered endpoint cannot be used
elsewhere (i.e., IP Gateway) until it has been renamed. Also, it will not
be saved in the configuration database.
NOTICE: Endpoint names of the form PPP-Sn and SCADA-Sn are reserved by the
system. These system-generated endpoints cannot be modified.
Figure 4.36 Endpoint Table Screen
You can add an endpoint in the Add Endpoint field and, when the screen
refreshes, you will be able to view that endpoint’s associated parameters. For
most applications, you will not have to modify the Endpoint Table and DLCI
Table.
Endpoint Details Screen
Select the <NDX> number to view the Endpoint Details screen (Figure 4.37),
which provides you with access to the configuration parameters described
below.