Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 237)

F r o n t P a n e l L C D I n t e r f a c e 5-19
DSR Data Set Ready can be set to “True,” “False,” or “Internal.” The “Internal”
option sets DSR “On” if the port is enabled and “Off” if the port is disabled.
Values: True, False, Internal
Default:True
DCD The Data Carrier Detect parameter can be set to “True,” “False,” or
“Internal.” If set to “Internal,” DCD is “On” when network carrier is being
received from the remote end, and is “Off” when network carrier is not being
received from the far end.
Values: True, False, Internal
Default:True
CTS The Clear To Send parameter can be set to “True” or “False.” If this
parameter is set to “Internal,” the CTS control lead follows the RTS control
lead from the DTE after a delay of a duration established by the RTS Delay
parameter.
Values: True, False, Internal
Default:True
RTS The Request To Send parameter determines where the unit reads the RTS
signal status from. If set to “Normal,” the unit gets RTS from the Serial pin. If
set to “True,” RTS is always perceived as “On.”
Values: Normal, True
Default:Normal
RTS Delay The RTS Delay parameter determines how long the unit waits before it
changes the level of CTS to match RTS when the CTS parameter is set to
“Internal.”
Values: Normal (~30 ms delay), Long (~100 ms delay)
Default:Normal
Tx Clock Used to select the clock that the unit uses to sample the data transmitted from
the DTE. When set to “Internal,” the data is sampled directly with the
transmit data clock that is also supplied to the DTE as Transmit Clock.
Values: Internal, External
Default:Internal
Inv Clock For use in DTE Packet mode to change the clock edge of the transmitted data.
Values: Enable, Disable
Default:Disable
Rate If the port is running in Packet mode, the Rate must be configured to the
desired port speed. In TDM mode, the port speed rate will be set by
configuring the next four parameters (Start Channel, Number of Channels,