Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 67)

W e b S e r v e r I n t e r f a c e 3-35
Message Size Maximum number of characters to buffer before sending a frame.
Values: 0
−
1024
Default: 256
Idle Character Delay Maximum number of idle character time to wait before sending a frame.
Values: 0
−
65535
Default: 10
Input Terminator Decimal value of the character that terminates a message before sending a
frame.
Values: 0
−
255
Default: 0
Data Direction Data direction that the port will support. If set to “Input,” the port will only
accept incoming data and will not transmit data. If set to “Output,” the port
will ignore any incoming data. If set to “Both,” the port will process all data.
Values: Input, Output, Both
Default: Both
SCADA Loopback Determines if and where SCADA will loopback received data.
Values: None, Loopback to Network, Loopback to Port
Default: None
The table below these parameters displays the SCADA statistics.
The SCADA Details screen provides the following user-activated buttons:
Figure 3.28 SCADA Device List Screen
Select the appropriate numbered link under the “Device column to access the
SCADA Device Details screen(Figure 3.29) where you can map SCADA
devices to endpoints.
Button Function
Submit Sets any values that have been changed.
SCADA Device List Displays a table that shows the mapping between
SCADA devices and endpoints (Figure 3.28).
Clear SCADA Statistics Clears all SCADA statistics.