Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 145)

V T 1 0 0 I n t e r f a c e 4-17
Current Pin Status The Current Pin Status, which shows the state of the RS-232 pins, is also
displayed on the Serial interface screens.
10/100 Ethernet (IP Details) Screen
If you select “Ethernet” from the Interfaces screen, you will bring up an IP
Details screen (Figure 4.12) that lets you view and/or modify the IP
parameters listed below.
Figure 4.12 IP Details Screen
Unit IP Address A unique Network address assigned to this unit.
Subnet Mask Defines the Network portion of the unit’s IP address.
Gateway IP Address IP address of the default gateway (router) on the LAN side of the unit.
DHCP Client If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and
Gateway addresses from a DHCP server located on the LAN side of the unit,
and the unit will use these addresses. If the DHCP request is unsuccessful, the
unit will use the configured addresses shown on this screen.
Client Identifier Displays a unique identifier for a specific IP address.
Ethernet Enables or disables a remote unit’s Ethernet port.
Physical Address Displays unique MAC address.
NOTICE: Always verify that a DHCP server is available on the network before
enabling DHCP Client. If, on power-up, a DHCP server is not found, a
60-second timeout will occur.