Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 146)

4-18 W A N s u i t e 5 1 6 0 / 5 1 3 0
NOTICE: If you manually change the IP address, you must “Save and Restart.”
(See Save and Restart on page 4-6.)
Select the Unit Access Table prompt on the Ethernet (IP Details) screen to
view the Unit Access Table (Figure 4.13), which specifies up to 10 different
IP networks that may access the unit. If no IP networks are supplied, any host
can access the unit. Select an <Ndx> number on the table to view the Unit
Access Details (Figure 4.14) that correspond with that number.
Figure 4.13 Unit Access Table
Figure 4.14 Unit Access Details
Supervisory Configuration Screen
The Supervisory Configuration screen (Figure 4.15) displays the current speed
of the Supervisory port interface along with other parameters as described
below. The Supervisory port supports only asynchronous character formats.