Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 20)

1-6 W A N s u i t e 5 1 6 0 / 5 1 3 0
• Static routes
• Static Address Resolution Protocol (ARP)
• Dynamic routing protocols, including RIP 1, RIP 2, and OSPF
• Un-numbered Network
• Address Management: NAT and DHCP
• Programmable alarm thresholds
• Transparent Bridging
• Configurable Serial (Data) Port:
• Supports V.35, EIA-530, and RS-232
• Security Features
• IP Host Access List
• Multilevel password access
• NAT
• Supervisory Control and Data Acquisition (SCADA):
• Diagnostics
• Data Monitor function shows all traffic activity on a given RTU port of
a remote site, as if a data scope were physically connected between the
WANsuite unit and the RTU.
• RTU loopback lets you set a remote unit’s RTU port in loopback mode
so that any data sent towards the RTU from the central site will be
echoed back towards the central site. Verifies data integrity to the RTU
port.
• TCP Server allows multiple connections to TCP clients.
• Asynchronous multicasting lets the WANsuite 5160/5130 transmit
identical data to multiple endpoints.
• SCADA traffic priority puts SCADA traffic in a specific queue over a
frame relay link and puts all other traffic (Ethernet, In-Band Management,
Serial Frame Relay) in a normal priority queue.
• Blowfish encryption on a per-DLCI basis with configurable encryption
key lengths up to 448 bits. This feature offers secure connections to
data-sensitive SCADA sites.
•
A Suite of Performance Monitoring Tools:
• Monitoring capability for up to 256 virtual circuits (Data Link Connection
Identifiers, or DLCIs)
• T1/FT1 performance monitoring, including complete diagnostic
capabilities and test modes and auto-learned DS0s.
• SLA monitoring and management
• Committed Information Rate (CIR) enforcement per DLCI
• Programmable alarm thresholds