Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 126)

3-94 W A N s u i t e 5 1 6 0 / 5 1 3 0
Log Out
The Log Out screen (Figure 3.93) is used to log the current user off of the
Web Server. The Log Out function is only available after user password
protection has been set. You will be logged out of the system automatically
1 hour after you user log on using a password to gain access; after this, you
will be required to enter the password to gain write access.
Figure 3.93 Log Out Screen
In-band Management
There are two ways to implement remote in-band management of a
WANsuite 5160/5130 unit. The first is to use the local router to route
management frames (Web browser or SNMP) between the local LAN and the
remote unit. The second is to use the local WANsuite 5160/5130 unit as an
independent gateway.
Use of Connected Local Router
If this method is used, there is no configuration required in the WANsuite
5160/5130s. Local Router A will route Web/SNMP frames from the PC to the
remote WANsuite 5160/5130s. The remote WANsuite 5160/5130 IP address
must be set within the same network as the remote routers B and C LAN
network.
Figure 3.94 Frame Relay Network
If the remote units are required to have an IP address for Networks that are
different from the remote routers, a static route will have to be configured in
the local router (Router A) for each remote WANsuite 5160/5130 to manage.
If Router A becomes unavailable, there is no way to reach the remote
WANsuite 5160/5130s.
PC
Router
A
FSM
FSM
FSM
Router
C
Router
B
WAN SUITE
5160/5130
WAN SUITE
5160/5130
WAN SUITE
5160/5130