Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 34)

3-2 W A N s u i t e 5 1 6 0 / 5 1 3 0
To access the Web Server interface, type the unit’s IP address in the
browser’s Address (or Location) field and press the “Enter” key.
Layout of Interface Screens
When you first access the Web Server interface, your browser will display a
screen that is divided into three frames. The upper frame forms a border
across the top of the screen; it identifies the Verilink unit in service and
displays the hardware and software revision and serial numbers under which
the unit is operating. The far right corner of the upper frame displays whether
or not a “Save and Restart” is necessary when parameters are changed on the
currently displayed screen.
The area beneath the upper frame is divided into two side-by-side frames. The
frame on the left side of this area depicts a hierarchical “tree” structure used
to navigate through the various interface screens. Each “branch” on the tree
guides you to more specific upper-level information about the unit and its
configuration. Note that the Interfaces, Applications, and Utilities branches do
not link to a page
−
these branches simply provide structure for navigation.
The frame on the right side of the screen will display the actual configuration
or display screen. The screen captures throughout this chapter show only the
configuration/display portion of the screen, except in the case of the Unit
screen, which shows all three frames. The Unit screen represents the top of
the navigation tree.
Unit Screen
The Unit screen shown in Figure 3.1 is the first screen displayed by your
unit’s Web Server interface. The Unit screen for the WANsuite 5130 is very
similar to the 5160, with the exception being that the 5130 has one Network
and one Serial interface listed in the navigation pane on the left-hand side of
the screen. The Unit screen lets you view and set specific information about
the unit in service.