Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 96)

3-64 W A N s u i t e 5 1 6 0 / 5 1 3 0
Figure 3.52 Circuit Details Screen
Endpoint Endpoint name. By default, the first circuit is always the LAN circuit. All
other circuits are associated with Endpoint names as defined in the Endpoint
Table shown in Figure 3.36 on page 3-42.
IP Address IP Address of the circuit.
IP Mask IP mask of the circuit.
Max Transmit Unit Maximum transmit unit this circuit will send at any one time.
Cost Represents the relative time of treatment of an IP packet. This value is used
when there are multiple routes to the same destination. When two or more
routes are available, the one with the lowest circuit cost is selected. A frame
relay circuit should have a higher value than a LAN circuit.
RIP Status Indicates whether or not RIP is enabled on this circuit.
Values: Enable, Disable
Default: Enable
Multicast Status Indicates whether or not Multicast is enabled on this circuit.
Values: Enable, Disable
Default: Enable
OSPF Status Indicates whether or not OSPF is enabled on this circuit.
Values: Enable, Disable
Default: Disable