Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 2)

ii W A N s u i t e 5 1 6 0 / 5 1 3 0
Copyright Notice Copyright © 2002 Verilink Corporation. All rights reserved. No part of this publication may be
reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language
in any form by any means without the written permission of Verilink.
Manual Reorder # 34-00298.M
August 2002
Trademarks Verilink
®
and WANsuite
®
are registered trademarks of the Verilink Corporation. FrameStart™,
WANsight™, and ServiceAware™ are trademarks of the Verilink Corporation.
All other brand and product names used herein are trademarks or registered trademarks of their
respective manufacturers.
Documentation
Disclaimer This document does not create any express or implied warranty about Verilink or about its prod-
ucts or services. Verilink’s sole warranty is contained in its product warranty. The end-user doc-
umentation is shipped with Verilink’s products and constitutes the sole specifications referred to
in the product warranty. Verilink has made reasonable efforts to verify that the information con-
tained herein is accurate, but Verilink assumes no responsibility for its use or for any infringe-
ment of patents or other rights of third parties that may result. The customer is solely
responsible for verifying the suitability of Verilink’s products for its use. Specifications are sub-
ject to change without notice.
Warranty Verilink's product warranty is included at the back of this document.
FCC Requirements This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communica-
tions. Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user is required to correct the interference at his own expense. This device must
also accept any interference received, including interference that may cause undesired operation.
WARNING: For use only with a certified Class 2 power supply. See Power Source in
Appendix A, Specifications.
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This equipment complies with Part 68 of the FCC Rules. On the rear or bottom of the unit is a
label that contains the FCC registration number and other information. If requested, provide this
information to the telephone company.
1 All direct connections to the network lines must be made using standard plugs and jacks
(compliant with Part 68). The table below presents a list of applicable registration jack
USOCs, facility interface codes (FICs), and service order codes (SOCs). These are required
when ordering service from the telco.
2 If the unit appears to be malfunctioning, it should be disconnected from the network lines
until the source of trouble is determined to be your equipment or the telephone line. If your
equipment needs repair, it should not be reconnected until it is repaired.
Port ID REN / SOC FIC USOC
1.544 Mbps SF
1.544 Mbps SF, B8ZS
1.544 Mbps ANSI ESF
1.544 Mbps ANSI ESF, B8ZS 6.0F 04DU9- BN
04DU9- DN
04DU9- 1KN
04DU9- 1SN
RJ-48C jack