PLANET GSW-4804SF - Manual (Page 12)

User’s Manual of GSW-4804SF
-12-
2.2 Install the Switch
This section describes how to install the Switch and make connections to the Switch. Please read the following topics and
perform the procedures in the order being presented. To install your Switch on a desktop or shelf, simply complete the following
steps.
2.2.1 Desktop Installation
To install the Switch on desktop or shelf, please follows these steps:
Step1: Attach the rubber feet to the recessed areas on the bottom of the Switch.
Step2: Place the Switch on the desktop or the shelf near an AC power source.
Step3: Keep enough ventilation space between the Switch and the surrounding objects.
#
Notice:
When choosing a location, please keep in mind the environmental restrictions discussed in Chapter
1, Section 4, and Specification.
Step4: Connect the Switch to network devices.
A. Connect one end of a standard network cable to the 10/100/1000Mbps RJ-45 ports or Gigabit SFP mini-GBIC
interfaces on the front of the Switch.
B. Connect the other end of the cable to the network devices such as printer servers, workstations or routers…etc.
#
Notice:
Connection to the Switch requires UTP Category 5 network cabling with RJ-45 tips. For more
information, please see the Cabling Specification in Appendix A.
Step5: Supply power to the Switch.
A. Connect one end of the power cable to the Switch.
B. Connect the power plug of the power cable to a standard wall outlet.
When the Switch receives power, the Power / System LED should remain solid Green.