PLANET GSW-4804SF - Manual (Page 14)

User’s Manual of GSW-4804SF
-14-
2.2.3 Installing the SFP transceiver
The sections describe how to insert an SFP transceiver into an SFP interfaces.
The SFP transceivers are hot-pluggabe and hot-swappable. You can plug-in and out the transceiver to/from any SFP interfaces
without having to power down the Switch. As the Figure 2-5 appears.
Figure 2-5 Plug-in the SFP transceiver
Approved PLANET SFP Transceivers
PLANET GSW-4804SF supports both Single-mode and Multi-mode SFP transceiver. The following list of approved PLANET
SFP transceivers is correct at the time of publication:
■
MGB-GT SFP (1000Base-T SFP transceiver )
■
MGB-SX SFP (1000Base-SX SFP transceiver )
■
MGB-LX SFP (1000Base-LX SFP transceiver )
Before connect the other switches, workstation or Media Converter.
1. Make sure both side of the SFP transceiver are with the same media type, for example: 1000Base-SX to 1000Base-SX,
1000Bas-LX to 1000Base-LX.
2. Check the fiber-optic cable type match the SFP transceiver model.
¾ To connect to 1000Base-SX SFP transceiver, use the Multi-mode fiber cable- with one side must be male duplex LC
connector type.
¾ To connect to 1000Base-LX SFP transceiver, use the Single-mode fiber cable-with one side must be male duplex
LC connector type.