70 poe pdcheck action – PLANET WGSW-48040HP User Manual

Page 105

Advertising
background image

Command Guide of WGSW-48040HP

pdcheck Allows user to enable or disable per port PD Alive Check function.

IP To set PoE device IP address here for system making ping to the PoE device.

<ipv4_addr> <ipv4_addr>

Default:

N/A

Usage Guide:

To configure Ping PD IP Address of PoE for specific interface

Example:

To configure Ping PD IP Address (10.101.10.10) of PoE for GigabitEthernet X/X.

Switch# configure terminal

Switch (config)# interface GigabitEthernet X/X

Switch (config-if) # poe pdcheck IP 10.101.10.10

4.2.45.70 poe pdcheck action

Command:

poe pdcheck action { reboot | alarm | reboot-alarm }

poe Power Over Ethernet.

pdcheck Allows user to enable or disable per port PD Alive Check function.

action Allows user to set which action will be applied if the

PD is without any response

alarm It means system will issue an alarm message via Syslog, SMTP.

reboot It means system will reset the PoE port that is connected to the PD.

reboot-alarm It means system will reset the PoE port and issue an alarm message via Syslog, SMTP.

Default:

N/A

Usage Guide:

To configure PD Ping Alive Check Action of PoE for specific interface

Example:

To configure PD Ping Alive Check Action (Alarm) of PoE for GigabitEthernet X/X.

Switch# configure terminal

Switch (config)# interface GigabitEthernet X/X

Switch (config-if) # poe pdcheck action alarm

-105-

Advertising