PLANET WGSW-48040HP - Manual (Page 128)

Command Guide of WGSW-48040HP
Command:
spanning-tree edge
spanning-tree Spanning Tree protocol
edge Edge port
Default:
Non-Edge
Usage Guide:
To enable edge port of CIST Normal Port Configuration for specific interface
Example:
To enable edge port of CIST Normal Port Configuration for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # spanning-tree edge
4.2.45.111 spanning-tree link-type
Command:
spanning-tree link-type auto | point-to-point | shared
spanning-tree Spanning Tree protocol
link-type Port link-type
auto Auto detect
point-to-point Forced to point-to-point
shared Forced to Shared
Default:
Auto
Usage Guide:
To configure point to point mode of CIST Normal Port Configuration for specific interface
Example:
To enable point to point mode (shared) of CIST Normal Port Configuration for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # spanning-tree edge
-128-