PLANET WGSW-48040HP - Manual (Page 148)

Command Guide of WGSW-48040HP
last-member-query-interval Last Member Query Interval in tenths of seconds
<IpmcLmqi : 0-31744> 0 - 31744 tenths of seconds
Default:
10
Usage Guide:
To configure Last-member-query-interval of IGMP snooping for specific VLAN
Example:
To configure Last-member-query-interval (100 seconds) of IGMP snooping for VLAN X
Switch# configure terminal
Switch (config)# interface vlan X
Switch (config-if-vlan)# ip igmp snooping last-member-query-interval 1000
4.2.46.11 ip igmp snooping priority
Command:
ip igmp snooping priority <CosPriority : 0-7>
ip Interface Internet Protocol config commands
igmp Internet Group Management Protocol
snooping Snooping IGMP
priority Interface CoS priority
<CosPriority : 0-7> CoS priority ranges from 0 to 7
Default:
0
Usage Guide:
To configure CoS priority of IGMP snooping for specific VLAN
Example:
To configure CoS priority (5) of IGMP snooping for VLAN X
Switch# configure terminal
Switch (config)# interface vlan X
Switch (config-if-vlan)# ip igmp snooping priority 5
-148-