PLANET WGSW-48040HP - Manual (Page 342)

Command Guide of WGSW-48040HP
Example:
To display the Loop protection information for GigabitEthernet 1/1.
Switch # show loop-protect interface GigabitEthernet 1/1
Loop Protection Configuration
======================================
Loop Protection : Enable
Transmission Time : 2 sec
Shutdown Time : 2 sec
GigabitEthernet 1/1
------------------------------
Loop protect mode is enabled.
Actions are both of shutdown and log.
Transmit mode is enabled.
No loop.
The number of loops is 12390.
Time of last loop is at 1970-01-01T14:58:28+00:00
Status is down.
4.20.64 show mac address-table
Command:
show mac address-table [ conf | static | aging-time | { { learning | count } [ interface
( <port_type> [ <port_type_list> ] ) ] } | { address <mac_addr> [ vlan <vlan_id> ] } |
vlan <vlan_id_1> | interface ( <port_type> [ <port_type_list> ] ) ]
show Show running system information
mac MAC Address Table information
address-table MAC Address Table
address MAC address lookup
aging-time Aging time
conf User added static MAC addresses
count Total number of MAC addresses
interface Select an interface to configure
learning Learn/disable/secure state
static All static MAC addresses
vlan Addresses in this VLAN
-342-