PLANET WGSW-48040HP - Manual (Page 145)

Command Guide of WGSW-48040HP
4.2.46.5 ip address dhcp
Command:
ip address dhcp
ip Interface Internet Protocol config commands
address Address configuraton
dhcp Enable DHCP
Default:
None
Usage Guide:
To configure IP address mode for specific VLAN
Example:
To configure IP address mode (DHCP) for VLAN X
Switch# configure terminal
Switch (config)# interface vlan X
Switch (config-if-vlan)# ip address dhcp
4.2.46.6 ip address dhcp fallback
Command:
ip address dhcp fallback <ipv4_addr> <ipv4_netmask>
ip Interface Internet Protocol config commands
address Address configuraton
dhcp Enable DHCP
<ipv4_addr> DHCP fallback address
<ipv4_netmask> DHCP fallback netmask
Default:
None
Usage Guide:
To configure DHCP fallback IP address for specific VLAN
Example:
To configure DHCP fallback IP address (192.168.1.10/24) for VLAN X
Switch# configure terminal
-145-