PLANET WGSW-48040HP - Manual (Page 144)

Command Guide of WGSW-48040HP
Default:
None
Usage Guide:
To exit current mode
Example:
To exit current mode.
Switch# configure terminal
Switch (config)# interface vlan X
Switch (config-if-vlan)# exit
Switch (config)#
4.2.46.4 ip address
Command:
ip address <ipv4_addr> <ipv4_netmask>
ip Interface Internet Protocol config commands
address Address configuraton
<ipv4_addr> IP address
<ipv4_netmask> IP netmask
Default:
None
Usage Guide:
To configure IP address mode for specific VLAN
Example:
To configure IP address mode (192.168.1.10/24) for VLAN X
Switch# configure terminal
Switch (config)# interface vlan X
Switch (config-if-vlan)# ip address 192.168.1.10 255.255.255.0
-144-