PLANET WGSW-48040HP - Manual (Page 253)

Command Guide of WGSW-48040HP
<ipv4_addr> IPv4 address
<ipv4_netmask> IPv4 netmask
Default:
None
Usage Guide:
To configure the Read / Write / Source network Community of SNMP
Example:
To configure the Read / Write / Source network Community (below table) of SNMP
Switch# configure terminal
Switch (config)# snmp-server community v3 public 192.168.0.15 255.255.255.0
4.2.160 snmp-server contact
Command:
snmp-server contact <line255>
snmp-server Set SNMP server's configurations
contact Set the SNMP server's contact string
<line255> contact string
Default:
None
Usage Guide:
To configure the sysContact string of SNMP
Example:
To configure the sysContact string (Server123) of SNMP
Switch# configure terminal
Switch (config)# snmp-server contact Server123
-253-