PLANET WGSW-48040HP - Manual (Page 23)

Command Guide of WGSW-48040HP
 Show the current IP Address
1. At the “#” prompt, enter “show ip interface brief”.
2. The screen displays the current IP address and Subnet Mask as shown in Figure 2-5 .
Figure 2-5: IP Information Screen
 Configuring IP Address
3. At the “#” prompt, enter the following command and press <Enter>. As shown in Figure 2-6 .
# configure terminal
(config)# interface vlan 1
(config-if-vlan)# ip address 192.168.1.100 255.255.255.0
The previous command would apply the following settings for the Managed Switch.
IP Address: 192.168.1.100
Subnet Mask: 255.255.255.0
Figure 2-6: Configuring IP Address Screen
-23-