Motorola MVME2300 Series - Manual (Page 76)

2-6 Computer Group Literature Center Web Site
Raven PCI Bridge ASIC
2
Figure 2-3. MPC to PCI Address Translation
You should take care to assure that all programmable decoders decode
unique address ranges, since overlapping address ranges will lead to
undefined operation.
MPC Slave
The MPC slave provides the interface between the MPC bus and the Raven
FIFOs. The MPC slave is responsible for tracking and maintaining
coherency to the 60x processor bus protocol.
The MPC slave divides MPC command types into three categories:
Address Only; Write; and Read.
If a command is of type address-only and the address presented at the time
of the command is a valid Raven address, the MPC slave will respond
immediately. The Raven will not respond to address-only cycles where the
address presented is not a Raven address. The response of the MPC slave
to command types is listed in
Table 2-2 .
MPC Bus Address 8 0 8 0 1 2 3 4
31 16 15 0
MSOFFx Register 9 0 0 0
15 0
+
PCI Bus Address 1 0 8 0 1 2 3 4
0 15 16 31
=