1 preparation, 1 switching on, 2 traverse to reference point – Siemens Sinumerik 810T User Manual
Page 100
Advertising
3 Operating Sequences
11.90
3.1 Preparation
3.1
Preparation
3.1.1
Switching on
When you switch the control and machine on:
Follow the instructions in the machine tool
manufacturer's documentation!
3.1.2
Traverse to reference point
After switching on, you traverse the individual axes to the reference points. This synchronizes
the control with the machine.
The position of the reference point and the
traversing rate are defined in machine data by the
machine tool manufacturer!
REF-
POINT
You select the ”REFPOINT” operating mode via softkey
or
...You set the operating mode selector switch on the
external machine control panel to this symbol (REFPOINT).
Sequence of operation
3-2
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)
Advertising