Siemens Sinumerik 810T - Manual (Page 134)

09.91 3 Operating Sequences
3.1.7 Flexible plane selection
3.1.7 Flexible plane selection
Sequence of operation
Call one of the following modes:
• PRESET
• JOG
• AUTOMATIC
• INC 1 ... INC 10 000
• REFPOINT.
Now press the softkeys “ PART PROGRAM”, “EDIT”
and “Plane” one after the other.
PART
PROG.
PLANE
Using the numeric keypad enter the channel No. of the
channel via which the part program is to be executed
(Channel 1 to 3).
... ...
If you wish to select one of the predefined planes G17, G18 or G19, press the appropriate
softkey.
The control then automatically enters the designations for the abscissa, ordinate and
applicate and the two interpolation parameters. All designations must have been defined by
the machine manufacturer in the appropriate NC MD 548*, 550*, 552* and 304*.
EDIT
and
This screen form appears on the
screen with the input field marked
inverse.
((Bild 810T/57 einmontieren))
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-33
SINUMERIK 810T, GA3 (BN)