Siemens Sinumerik 810T - Manual (Page 227)

09.91 3 Operating Sequences
3.2.7 ”JOG” mode
3.2.7 ”JOG” mode
In this mode, machining is performed via the NC in JOG/manual mode, but it is not
programmed.
You traverse the axes with the direction keys.
The traversing speed is defined in machine data.
Operate the operating mode selection key in the
integrated machine control panel, and then the
”JOG” softkey or ...
... set the operating mode selector switch in the
external machine control panel to this symbol.
By operating the direction keys, you cause the axes
to traverse in ”jog” mode!
You can traverse a maximum of 2 axes at the same
time.
The red ”Feed hold” LED display, must not be
bright during the sequence of operation.
JOG
or
– Z
– X
+X +Q
– Q
+Z
Sequence of operation
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-121
SINUMERIK 810T, GA3 (BN)